Kontron KISS 1U PCI 762 - Manual (Page 20)

7. Product Description KISS 1U_SBC_762 – User's Guide (Version 1.00)
7.2.1.2.
Additional Ports
Depending on the ordered system configuration, your system cam be equipped with on-board interfaces (e.g. serial
interface) routed to the rear panel (refer to Fig. 15, pos 3 and pos. 4). These ports allow you to connect different
peripherals.
Information and technical data can be found in the corresponding board manual of the installed
SBC card.
You can download the relevant board manual for your system configuration from our web site at
www.kontron.com by selecting the product name.
Refer also to the “KISS 1U Systems - Configuration Guides” on our web site.
7.2.2. Power Supply and ON/OFF Switch of the PSU
The power supply is located on the rear side of the KISS 1U platform.
The KISS 1U platform is equipped with an AC wide range power supply unit. The corresponding nominal voltage range can
be found on the type label on the right side of the system.
Bracket that secures
the On/Off switch
Fig. 17: Detail:
AC Wide Rang PSU
Please observe that the ON/OFF switch of the AC wide range PSU (Fig. 17) does not disconnect the
KISS 1U platform from the main power source. Even you turn off the system using the power button (Fig.
8, pos. 7) or the ON/OFF switch of this PSU, there is still a standby-voltage of 5 VSb on the SBC.
Hint for the ON/OFF switch of the AC Wide Range PSU (Fig. 17):
This switch is factory-set to “ON” and secured in this position by a bracket (Fig. 15, pos. 9).
Don’t switch OFF the PSU ON/OFF switch during operation.
18 www.kontron.com