Kontron KISS Stor Slim User Manual
Page 3
Advertising
KISS Stor Slim
3
Setup your KISS Stor Slim
1. Load hard drives to each drive carriers, and secure the hard drives by
screwing.
2. Power down your host computer and mount the RAID box in the host.
3. Connect the SATA or IDE cable and DC power cable to RAID box from host
computer.
4. Connect the RS-232 cable to RAID box RS-232 port and COM port of the host.
(Option for upgrading firmware or GUI remote monitor)
Caution
Turn off and disconnect all electrical power from the system
before beginning installation.
Note
There is a triangular symbol “▲” on both PCB
connector(J10) and RS-232 cable connector, please
make sure that you connect in the right direction (both
triangle symbols match each other).
Advertising