Harbor Freight Tools Model 94996 - Manual (Page 6)

Page 6 SKU 94996 For technical questions, please call 1-800-444-3353
9. Connect the air hose from the air compressor (not supplied) to the Air Inlet (upper
right side of Tank). Please note: Only use compressed air with the Paint Spray Gun
Washer.
10. Turn on the air compressor and set its pressure to 40 PSI.
11. Turn the Air Inlet Switch (next to air supply hose) to the on (air flow) position. Cleaning
will begin. Under normal conditions, cleaning should take one minute. Dirtier units
may take longer.
Turning the System Off
1. Turn off the Air Inlet Switch (upper right side of Tank). See photo below.
2. Turn off Output Hose Switch.
3. Open Tank Lid and remove clean Spray Gun and Cup.
4. When finished with the Washer, disconnect from the air supply.
REV 07g, 07j, 08d