La-Z-Boy PowerReclineXR 08/11/2014-01/18/2015 - Manual (Page 10)

PowerReclineXR ® with Massage & Heat
Operating Instructions
– To reduce the risk of serious injury:
• Do not use unit if power control is damaged or wet. Do not use unit if the hand wand has
been dropped in water or any liquid. Contact your La-Z-Boy ® dealer for service.
WARNING
Press and hold the button down
to return the back to the upright
position. Release the button
to stop the back in any reclined
position or when fully raised.
Press and hold the button
down to close the legrest
and return the chair body.
Release the button to stop the
legrest in any extended position
or when fully closed.
Press and hold the button
down to raise the back and
close the legrest and return
the chair body. Release the
button to stop the chair in
any position or when the
back is fully raised and the
legrest is fully closed.
Press and hold the button down
to recline the chair back. Release
the button to stop the back in
any reclined position or when
fully reclined.
Press and hold the button down
to extend the legrest and tilt the
chair body backward. Release
the button to stop the legrest
in any extended position or
when fully raised.
Press and hold the button down
to recline the back, extend the
legrest and tilt the chair body
backward. Release the button
to stop the chair in any position
or when the back is fully reclined
and the legrest is fully raised.
MASSAGE
Activates the massage
system. Press once for a
15-minute massage. Two
15-minute massage cycles
can be activated
consecutively, followed by
a 30-minute cool down.
OFF - (Blue)
ON - Push 1x (Green)
MASSAGE MODES
OFF - (Blue)
CONSTANT - Push 1x Massage
is constant. (Green )
WAVE - Push 2x Massage moves side
to side in a wave-like motion. (Amber)
PULSE - Push 3x Massage turns on and
off to simulate a pulsing action. (Red)
HEAT
Activates the heat feature.
Use independently or with
the massage.
OFF - (Blue)
LOW - Push 1x (Amber)
HIGH - Push 2x (Red)
Push 3x to turn off (Blue)
Heat will activate for
15-minutes. Two 15-minute
heat cycles can be activated
consecutively, followed by a
30-minute cool down.
MASSAGE INTENSITY
OFF - (Blue)
LOW - Push 1x (Green )
MEDIUM - Push 2x (Amber)
HIGH - Push 3x (Red)
PowerReclineXR ®
Troubleshooting
– To reduce the risk of serious injury:
• Do not attempt to disassemble or service the pump or motor; no serviceable parts are
inside. Contact your La-Z-Boy ® dealer for service.
• Check the condition of the power transformers, electrical cords, plugs, and connectors
monthly. Keep the power transformers and electrical cords away from heat sources.
Never operate the unit with a damaged power transformer, electrical cord, plug, or
connector. Contact your La-Z-Boy
® dealer for service.
• The PowerReclineXR ® units are intended for a single occupant not exceeding 300 pounds
per seat. Do not operate an individual seat with more than one occupant in or on any part
of the individual seat.
WARNING
Troubleshooting for Legrest Operation
If the legrest stops moving while closing, it may have encountered an obstruction.
1. Check to make sure there are no obstructions. Lift and hold the legrest up, look for obstructions
and remove them.
2. The legrest uses spring tension to close, and will close quickly when the obstruction is removed.
Release the legrest slowly to prevent it from slamming shut.
Troubleshooting for PowerReclineXR ®
1. Make sure the 120 volt power cord is plugged into an electrical outlet.
2. Check the power transformer to make sure the green LED power indicator light is on.
3. Make sure the electrical outlet is working. For example, make sure there are no blown
fuses or tripped circuit breakers.
4. Make sure all the connectors are secure; refer to the Assembly Instructions.
5. Make sure the electrical cords are not crimped or pinched. Make sure the electric cord
or plug is not damaged.
6. Make sure the operating capacity has not been exceeded and there is only one occupant
in the individual seat or unit; refer to the Operating Instructions.
Troubleshooting for Massage and Heat Function
If the massage or heat function does not work:
1. Make sure the automatic time-out operation has not been activated, indicated by either
the MSG button or the HEAT button flashing for 5 seconds. If either button is blinking, the
system is in a 30-minute cool down period. Following the cool down period, press the
MSG button to restart the massage, or press the HEAT button to restart the heat.
2. Refer to the Troubleshooting for PowerReclineXR ® steps 1-6 above.
3. Make sure the massage and heating pad connectors are secured; refer to the Assembly Instructions.
If the PowerReclineXR ® still does not operate properly, contact your dealer for instructions on
returning the unit for examination and repair. Except for the replacement of the power transformer,
never attempt to make any repairs or adjustments yourself.
(Troubleshooting Instructions Continued)
19 18