Lifesmart LS-3ECO - Manual (Page 14)

14
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The heater does not
turn on . 1 . The power cord is not plugged
in .
2 . The electricity at the main fuse
box is not working .
3 . The battery in the remote control
is dead .
4 . The thermostat on the heater
is set lower than the room
temperature .
1 . Plug the power cord into an electrical
outlet .
2 . Check the electricity at the main fuse
box .
3 . Replace the batteries in the remote
control .
4 . Increase the thermostat temperature
on the heater for a higher heat
setting .
The heater displays
an error code “E1” 1 . The heater has overheated .
2 . Insufficient power to the unit
3 . The air filter is clogged .
4 . Insufficient air flow to the heater . 1 . Unplug the heater from the wall, wait
a few seconds then plug the power
cord back in .
2 . Make sure the unit is plugged into
a dedicated 3-prong outlet, with no
extension cords or surge protectors .
3 . Clean the airfilter located on the back
of the unit . see page 13 .
4 . Move the unit at least 3ft from the
wall .
The heater displays
an error code “E2” 1 . Temperature sensor not
functioning properly .
1 . Please contact technical support .