Losi LOSB0115 - Manual (Page 5)

5 LOSI Tuff COunTry XXX-SCT rTr • InSTruCTIOn manuaL
EN
spektruM dX2l radIo systeM
12 13 11 14 15
16 17
18
10
5
8
1
2
4
9
7
6
3
19
1. Steering Wheel Controls direction (left/right) of the model
2. Throttle Trigger Controls speed and direction (forward/brake/reverse) of the model
3. r.O.S.S. Button Used with vehicles featuring the R.O.S.S. Remote Start System
4. antenna Transmits the signal to the model
5. On/Off Switch Turns the power ON/OFF for the transmitter
6. Indicator Lights
- Solid green (right) light—indicates adequate battery power
- Flashing green light—indicates the battery voltage is critically low. Replace batteries
- Solid red (left) light—indicates good signal strength. When the red light fades,
signal strength is weakening
7. ST. Trim Adjusts the “hands off” direction of the model
8. TH. Trim Adjusts the motor speed to stop at neutral
9. Steering dual rate Adjusts the amount the front wheels move
when the steering wheel is turned left and right
10. Battery Cover Covers and holds the batteries that power the transmitter
11. BInd Button Puts the transmitter into Bind Mode
12. ST. reV Reverses the function of the steering when the wheel is turned left or right
13. TH. reV Reverses the function of the speed control when pulled back or pushed forward
14. TH-F Forward Endpoint—Adjusts the amount of full throttle
15. TH-B Brake Endpoint—Adjusts the amount of full brake
16. ST-L Steering Left Endpoint—Adjusts the amount of left steering travel
17. ST-R Steering Right Endpoint—Adjusts the amount of right steering travel
18. Throttle Limiter Limits the throttle to Low (50%), Medium (75%) or High
(full throttle is equal to the high Throttle Travel position)
19. Bind plug Compartment
For more information on the transmitter, go to www.horizonhobby.com and click
on the support tab for the Spektrum DX2L to download the instruction manual.
InSTaLLInG THe TranSmITTer BaTTerIeS
1. Push in the battery cover a small amount to release the retaining tab,
then remove the cover.
2. Install 4 AA batteries, taking care to align the battery polarity to the diagram
in the transmitter’s battery case.
3. Carefully reinstall the battery cover by aligning the tabs with the slots on the transmitter.
CauTIOn: Do not remove the transmitter batteries while the model is powered
on or while operating, as a loss of model control, damage or injury can result.
5 LOSI Tuff COunTry XXX-SCT rTr • InSTruCTIOn manuaL