Losi LOSB0127 - Manual (Page 7)

7 - EN 7 - E 7 - E EN N EN N
Tuning, Adjusting and Maintaining the TEN-SCTE Tuning, Adjusting and Maintaining the TEN-SCTE
Periodically examine your TEN-SCTE for the following:
• Keep your vehicle clean using a brush to remove dirt
and dust.
• Look for cracks in the suspension arms and other
molded parts.
• Check that the tires are still glued to the wheels.
• Check that all the wheel bearings are clean and lubricated.
• Using your tools, attempt to tighten all the screws and
nuts.
• Verify that the Camber Links and Steering linkage are
not bent.
• Check that the Toe and Camber settings are as desired
and equal.
• Check the Drivetrain:
o Check the Spur gear for wear.
o Check the Pinion gear.
• Take the shocks off the vehicle and check, especially if they
appear to be leaking as it is time to rebuild them.
• Look over all the wiring and connections for bare wire or
any place which could lead to a short circuit.
After you become familiar with driving your TEN-SCTE,
you may need to reset or make adjustments for better
driving performance.
Just as in a real car, alignment is an important factor in your
vehicle’s handling. When you are ready to make adjustments
it is a good idea to have a fl at work space to place your vehicle
on. This will enable you to easily and more quickly make both
Toe-in and Camber adjustments. These adjustments should be
set with the vehicle sitting at its normal ride height.
Three-Position Battery Tray: Your TEN-SCTE comes with
a three-position battery tray to alleviate the need for foam
blocks. You can move the included battery stops in order to run
the battery in a back, middle, or forward position. Please see
pictures as follows.
BACK
MIDDLE
FORWARD