Mercedes-Benz C-Coupe 2014 Owners Manual - Manual (Page 56)

X Adjust the seat and move the backrest to
an almost vertical position (
Y
page 92).
X
Pull the seat belt smoothly through belt
sash guide :.
X Without twisting it, guide the shoulder
section of the seat belt across the middle
of your shoulder and the lap section across
your pelvis.
X Engage belt tongue ; in buckle =.
X If necessary, pull upwards on the shoulder
section of the seat belt to tighten the belt
across your body.
All seat belts except the driver's seat belt are
equipped with a special seat belt retractor to
securely fasten child restraint systems in the
vehicle. For further information on special
seat belt retractors, see (
Y
page 59).
For more information about releasing the seat
belt with release button ?, see "Releasing
seat belts" (
Y
page 54).
Seat belt adjustment
The seat-belt adjustment function adjusts the
driver's and front-passenger seat belt to the
upper body of the occupants.
The belt strap is tightened slightly when:
R you engage the belt tongue in the belt
buckle and you then turn the SmartKey to
position 2 in the ignition lock.
The seat-belt adjustment will apply a
retraction force if any slack is detected
between the occupant and the seat belt. Do
not hold on to the seat belt tightly while it is
adjusting. You can switch the seat-belt
adjustment on and off in the on-board
computer (
Y
page 202).
The seat-belt adjustment is an integral part of
the PRE-SAFE ® convenience function. More
information about PRE-SAFE ® can be found
in the "PRE-SAFE ® (anticipatory occupant
protection system)" section (
Y
page 50).
Releasing seat belts
X
Press release button ? on belt buckle =.
X
Guide belt tongue ; to belt sash
guide :.
i If you have guided the seat belt back, it is
turned 180°. This is necessary in order to
guarantee that the seat belt is not twisted
and that it is routed correctly when the belt
is fastened.
! Make sure that the seat belt is fully rolled
up. Otherwise, the seat belt or belt tongue
will be trapped in the door or in the seat
mechanism. This could damage the door,
the door trim panel and the seat belt.
Damaged seat belts can no longer fulfill
their protective function and must be
54
Occupant safety
Safet
y