On-board computer and displays, Menus and submenus – Mercedes-Benz C-Coupe 2013 Owners Manual User Manual
Page 203
R
Changing the vehicle settings
(
Y
page 203)
R
Changing the convenience settings
(
Y
page 203)
R
Restoring the factory settings
(
Y
page 204)
Instrument cluster
Selecting the unit of measurement for
distance
The
Display Unit Speed-/Odometer:
function allows you to choose whether
certain displays appear in kilometers or miles
in the multifunction display.
You can determine whether the multifunction
display shows some messages in miles or
kilometers.
X
Press the = or ; button on the
steering wheel to select the
Sett.
menu.
X
Press the : or 9 button to select the
Instr. Cluster
submenu.
X
Press a to confirm.
X
Press the : or 9 button to select the
Display Unit Speed-/Odometer:
function.
You will see the selected setting:
km
or
miles
.
X
Press the a button to save the setting.
The selected unit of measurement for
distance applies to:
R
the digital speedometer in the
Trip
menu
R
the odometer and the trip odometer
R
the trip computer
R
current consumption and the range
R
the navigation instructions in the
Navi
menu
R
cruise control
R
DISTRONIC PLUS
R
ASSYST PLUS service interval display
Selecting the permanent display function
You can determine whether the multifunction
display permanently shows your speed or the
outside temperature.
X
Press the = or ; button on the
steering wheel to select the
Sett.
menu.
X
Press the : or 9 button to select the
Instr. Cluster
submenu.
X
Press a to confirm.
X
Press the : or 9 button to select the
Permanent Display:
function.
You will see the selected setting
Outside
Temperature
or
Speedometer [km/h]
(USA)/
Speedometer [mph]
(Canada).
X
Press the a button to save the setting.
i
The speed is shown in km/h (USA)/mph
(Canada).
Lights
Switching the daytime running lamps on/
off
Daytime running lamps are required by law
(Canada only). You cannot set the "daytime
running lamps" function via the on-board
computer.
X
Press the = or ; button on the
steering wheel to select the
Sett.
menu.
X
Press the : or 9 button to select the
Lights
submenu.
X
Press a to confirm.
X
Press the : or 9 button to select the
Day Lights
function.
If the
Day Lights
function has been
switched on, the cone of light and the
W symbol in the multifunction display
are shown in red.
X
Press the a button to save the setting.
Further information on daytime running
lamps (
Y
page 107).
Menus and submenus
201
On-board
computer
and
displays
Z