Mounting the spare wheel, The vehicle, Practical hints – Mercedes-Benz CLS-Class 2011 Owners Manual User Manual

Page 274: Flat tire

Advertising
background image

Open doors only when conditions are safe
to do so.

X

Have any passenger exit the vehicle at a
safe distance from the roadway. Open
doors only when conditions are safe to do
so.

Mounting the spare wheel

Introduction

X

Prepare the vehicle as described
(

Y

page 271).

X

Take the following out of the vehicle:

R

spare wheel

R

jack

R

vehicle tool kit

R

wheel wrench

R

electric air pump (required for vehicles
with spare wheel with collapsible tire
only)

For information on where to find the
respective items, see “Where will I find ...?”
(

Y

page 224) and (

Y

page 226).

i

Vehicles without spare wheel are not

factory-equipped with the tools required for
a wheel change such as a jack or a wheel
wrench. Some tools required for a wheel
change are specific to your vehicle.
Contact an authorized Mercedes-Benz
Center to obtain the tools approved for
your vehicle. This section describes the
wheel change using the tools approved and
recommended for your vehicle.

Removing tensioning straps from spare

wheel
This description applies to vehicles with 19"
spare wheel with collapsible tire only.
A 19" spare wheel with collapsible tire has
two tensioning straps on it that must be
removed before mounting the spare wheel.

X

Press on both clips ; simultaneously to
release buckle :.

X

Store the tensioning straps in a safe place.
You will need them to store the spare wheel
in the trunk after use (

Y

page 226).

Lifting the vehicle

G

Warning!

When jacking up the vehicle, only use the jack
which has been specifically approved by
Mercedes-Benz for your vehicle.
The jack is designed exclusively for jacking up
the vehicle at the jack take-up brackets built
into both sides of the vehicle. Make sure the
jack arm is fully seated in the jack take-up
bracket. The jack must always be vertical
when in use, especially on inclines or
declines.
The jack is intended only for lifting the vehicle
briefly for wheel changes. It is not suited for
performing maintenance work under the
vehicle. To help avoid personal injury, use the
jack only to lift the vehicle during a wheel
change.
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always lower the vehicle onto sufficient
capacity jackstands before working under the
vehicle.
Always engage the parking brake firmly and
block the wheels with wheel chocks or other
sizeable objects before raising the vehicle

272

Flat tire

Practical hints

219_AKB; 4; 54, en-US
d2ureepe,

Version: 2.11.8.1

2009-05-11T16:21:02+02:00 - Seite 272

Advertising