Navigation, Introduction – Mercedes-Benz SLK-Class 2009 COMAND Manual User Manual
Page 59
X
To exit menu: Press = or ;.
X
Hide menu system if applicable
(
Route Mode
This function allows you to set the following
options for route guidance:
R
Avoid Highways
R
Avoid Toll Roads
R
Avoid Tunnels
R
Avoid Ferries
R
Avoid AutoTrains
1
Sets route options
Setting Route Options
X
To set: Display menu system is applicable
X
Select Navi£Mode.
X
To switch option on/off: Select required
option.
Depending on the previous status, the
option will be switched on Ç or offc.
You may activate several options.
i
The calculated route may include ferry
connections, for example, even if the
operation Avoid Ferries has been
activated.
i
If you change the route type setting when
route guidance is active, COMAND
calculates a new route.
Block Area
You can define an area within the map display
that is not to be used by the system in
calculating a route, if possible.
i
The calculated route may include a
blocked area if the destination is within a
blocked area or if the destination can only
be reached using roads that lead through a
blocked area. Highways cannot be blocked.
X
To set, change or delete: Display menu
system if applicable (
X
Select Navi £Block Area.
If no areas were previously set, the map
display appears ready to select an area.
If areas were previously set, the blocked
area list appears.
X
To move the map: Press
9, :,; or =.
X
To set the map scale: Press U or
T.
The map scale is displayed.
X
To enlarge the map: Press U.
X
To reduce the map: Press T.
X
To set the blocked area: Press 9.
The blocked area appears in red.
X
Press U or T to change the size of
the blocked area.
X
Press 9.
The area is added to the blocked area list.
Introduction
57
Navigation
Z