Warning – Modern AG Tiller User Manual

Page 9

Advertising
background image

Rotary tiller - 9

fiGUre i

OPeraTiNG iNSTrUCTiONS

SteP 1 - Before each use perform the maintenance

described in maintenance section.

SteP 2 - Read, understand, and follow the informa-

tion on safety training, preparation, start-

ing and stopping safety, operational safety,

transport safety warning sections of this

manual.

SteP 3 - With the rotary tiller positioned on level

ground, adjust the tractor lift arms so that

when lifted, the rotor bar remains parallel to

the ground.

SteP 4 - With the rotary tiller attached to the trac-

tor, raise and support the tiller with suitable

blocks. adjust the skids, located on the sides

of the tiller. the adjustment bolts for both

right and left sides should be positioned in

the same adjustment hole. this al-lows the

tiller to till the same depth on each side. ad-

just the back plate, with regulating chain,

until the desired mulching effect is found.

Note: Never attempt to adjust the rotary tiller while the

tractor is running.

SteP 5 - Raise the tiller and remove the blocks. Lower

the tiller to the ground.

SteP 6 - With the tractor at idle RPm and the til-

ler lifted off of the ground, engage PtO and

slowly advance throttle to 540 PtO RPm.

nOte: Rotary tiller is designed to run at 540

PtO RPm only.

SteP 7 - Select a low gear for the tractor and begin

to move forward. tractor ground speed is

to be controlled by gear selection only and

not engine speed. as the tractor moves for-

ward, slowly lower the tiller down. allow the

tiller tines to gradually engage the ground.

never travel at a fast ground speed while using the

tiller, this could damage it. never attempt to turn the

tractor or travel in reverse with the PtO engaged and

the tiller in the ground. always raise the tiller out of

the ground when backing up or attempting to turn.

Failure to due so may cause damage to the tiller.

SteP 8 - after each use clean all debris from the tiller

tines. Replace any missing or illegible safety

decals. Inspect for any damaged or worn

parts and replace before next use. Store ro-

tary tiller in a dry environment.

OPeraTiNG SeCTiON

WarNiNG

Advertising