Channel Vision DVR-4N - Manual (Page 89)

-
NETWORK VIEWER INSTALLATION
9.8.3 PTZ
his menu allows you to control the PTZ camera through the network.
Click the “PTZ” button to display the following PTZ controller.
Click t and button to tilt up or down.
Click t and button to pan left or right.
Click the “ZOOM(
-
or +)” button to zoom in or out.
Click the “FOCUS(
-
or +)” button to obtain the clearest picture.
And then select the speed.
A preset is user-defined camera position using pan and tilt, zoom, and focus commands. The DVR
has programming capacity for 16 preset locations.
Move the camera to a desired position using the PTZ control buttons.
ton after 1 . (Repeat 1 and 2 )
Move to a preset
Click one of the “Move” buttons to move to the desired setting.
The camera will move to the programmed preset position.
.8.4 SETUP
ou can modify DVR MENU setup through the network.
T
1
2 he
3 he
4
5
6
- Preset setup
-
Program a preset
1
2 After setting the PTZ camera, click one of the desired “Set” buttons, 1~16 of Preset.
3 To continue setting the preset camera, click another “Set” but
-
1
2
9
Y
NOTE
If you need some more information about the control keys, please refer to Chapter 5 Operation.
NOTE
You can enter the PTZ mode only while connecting the PTZ camera.
88