Origin Live Ultra Turntable Kit - Manual (Page 7)

7
Turntable assembly
P R E P A R A T I O N
When you unpack the deck, check that you have all the parts listed in the parts list.
Undo the 2 transit bolts which hold the sub-chassis onto the topboard of the turntable plinth – see diagram
below to identify the transit bolts.
D I A G R A M O F S U B - C H A S S I S A S S E M B L Y
P L I N T H A N D L I D A S S E M B L Y
F I T T H E R U B B E R F E E T
Fit the 4 rubber feet to the underside of the plinth – one foot at each corner. Use the 4 nails provided for this
purpose – they only need to be hammered in till they are just below the surface of the rubber so as not to mark
the surface the deck rests on.
D I A G R A M O F L I D A S S E M B L Y A N D R U B B E R F E E T
PLINTH SIDE WALL
LID
Washer
HINGE
HINGE SUPPORT
HOUSING
M4 HINGE BOLTS
PLINTH RUBBER
FOOT