Origin Live MK3 arms ( upward facing points dual pivot) - Manual (Page 4)

Page 4
The dual pivot bearing is a very precise and in some
ways delicate mechanism. Every care has been taken to
ensure that the arm reaches you in perfect condition
such that the bearings are accurate and very low in
friction. If you need to send the arm anywhere, the
following proceedure must be followed carefully.
Remove the counterweight and turn the vta adjuster
wheel up as high as possible (i.e anti-clockwise when
looking down on the arm ) - this enablles the arm to sit
in the box at the correct height.
Fit and nip tight the transit bolts and nylon
washers - the nylon washers are critical to avoid
damaging the paint. If you have carried this out
successfully the arm is clamped such that the end
caps are above the horizontal centre line of the
yoke.
Only now can you place the arm in the arm clip
and tape it down to the arm plate as shown on
page 3 - this operation must not be caried out
before inserting the transit bolts.
Pack the arm into it’s wooden box using the
foam packing peices
Pack the arm into it’s wooden box using the
foam packing peices.
CORK PACKING PEICES WEDGING
ARM TUBE TIGHTLY INTO TOP OF
YOKE AND TAPED ON - (use double
thickness of 1.5mm thick cork folded
over)
Origin Live Ltd, Unit 5, 362b Spring Road, Sholing, Southampton, SO19 2PB
www.originlive.com [email protected]
Repacking the arm for transit
2 PEICES OF CORK PACKING EITHER
SIDE OF ARM TUBE AND THEN
WEDGED INTO THE YOKE HOLE TO
ENSURE THE ARM REMAINS CENTRAL
IN THE YOKE