Origin Live OL Armboard installation on Technics SL1200 - Manual (Page 4)

Place 3 washers over the holes in the arm well that
the armboard will be fitted to.
Thread the 3 off nylock nuts with washers onto the
underside of the bolts just fitted to hold on the new
armboard. Tighten nuts but not too hard or you may
crush the mounts on the deck.
Orientate the arm so that it is in the correct position
parallel to the edge of the turntable.
Enlarge the hole for the arm leads in the outer
moulding. This enables you to access the large nut on
the underside of the armboard should you ever need
to adjust it. Use a Stanley knife blade to cut the hole.
Refit the inner moulding using the 6 screws. Ensure
that the arm cable goes through the hole in the arm
base and that the mains lead is clear etc to enable the
inner base to fit down properly.
Re-fit outer base, platter and platter mat.
The deck is now ready for you to set up the cartridge - The Origin Live threaded VTA adjuster makes this
relatively easy but if you do not have one then you can use spacing washers to raise the height of the arm if
necessary.
We wish you many hours of enjoying your increased level of listening pleasure.
For tonearm options see http://www.tonearm.co.uk/dj-technics-arm.htm
Origin Live, Unit 5, 362b Spring Road, Sholing, Southampton, SO19 2PB
www.originlive.com [email protected]
Page 4
Place the armboard in position in the arm well.
Fit the three M4 x 16mm allen bolts through the armboard,
washers and Technics deck.