Nimh/nicd battery charge setup – ProgressiveRC 4010Duo iCharger User Manual
Page 22
iCharger Synchronous Balance Charger/Discharger
4010DUO
- 22 -
NiMH/NiCd Battery Charge Setup
Select Program→Charge to enter Charge setup interface.
Note: Charge Mode has Normal and Reflex modes available; use reflex mode to charge the battery, it
can reduce the heat in the battery; please see charging principle on Page38
NiMH/NiCd Battery Charge Advanced Setup
Click "
" to enter NiMH/NiCd CHARGE OPTION SETUP interface, after setting click "
" to return to the
previous interface.
Note: For the over-discharged NiMH/NiCd battery, the voltage may be close to 0V, tick Allow 0V
Charging to allow charge with 0V.
Tick Trickle Enable→Enable to activate trickle charge and set the parameters, after setting click"
" to return to the
previous interface.
Note: Tick Enable to activate trickle charge.
Trickle charge means when the standard charge is completed, the charger will charge the
battery with the setting trickle current until the setting trickle timeout, then to stop the
charging process.
NiMH/NiCd Battery Charge Safety Setup
Click "
" to enter CHARGE SAFETY SETU interface, see details about setting on Page19 LiPo/LiIo/LiFe Battery
Chg Current:
0.05A-40A; default: 2A
Chg Mode:
Normal (default), Reflex
Sensitivity:
1mV-20mV; default: 3mV
Delay time:
0Min-20Min; default: 3Min
Trickle current:
0.02A-1A; default: 0.05A
Trickle timeout:
1Min-999Min; default: 5Min