ProgressiveRC 4S Gold FMA Cellpro - Manual (Page 5)

5
About the data display
The diagram below explains the data display, how to view data about the pack being charged, and
how to manually set the charge current.
Hold to set Mode
0.25A LiPo 4.20V
1=3.88V 2=3.88V
3=3.88V 4=3.91V
0.019 Ah added
Charging @ 0.60A
15.52V Fuel= 49%
LiPo FAST CHARGE
Batt V Fuel=Lev%
LiPo Checking V.
Batt V Fuel=Lev%
LiPo Chgr. Ready
Start
Connect charger
to power source
Connect pack
to charger
Press
Mode Button
Charger status:
LiPo FAST CHARGE
LiPo BALANCING
LiPo LOW RESTORE
LiPo SAFETY CHG.
LiPo Cold W. BAL
LiPo CHARGE DONE
LiPo Checking V.
Press
Mode Button
Press and hold
Mode Button,
then...
release
Mode Button
when desired
current appears
To set specific charge mode
and current (at any time)
Note: In A123 Mode, "A123" will appear
where "LiPo" appears in these examples.
Press
Mode Button
Total pack voltage
Available capacity (as a
percent of total pack capacity)
Capacity added to pack
during this session
Individual cell voltages
Charge current sequences from
0.25A to 4.0A in 0.25A increments,
displays 1.0C, 2.0C, 3.0C, STORE
and A123 then repeats
This line shows
Charge current Chemistry Charge Voltage
Charging current
Tip: The charger stores the latest current setting.