Turning on the rear defogger, Valet take-over – CLIFFORD G4102X User Manual

Page 27

Advertising
background image

27

© 2008 Directed Electronics. All rights reserved.

Turning on the rear defogger

The rear defogger (if connected) is programmed to automatically activate

when remote start is turned on. If the interior cabin temperature is above 55˚ F

the defogger will not activate.

To manually activate the rear defogger after remote start is on:

Press

four times, and then press . The parking lights flash 4 times to

confirm the defogger activation.

Valet take-over

The Valet take-over feature allows the vehicle to remain running after the key

has been removed from the ignition. This feature is useful for occasions when

you want to exit and lock the vehicle for short periods of time, but would like

to leave the motor running and the climate controls on.

To perform Valet take-over:

Before turning Off the engine, press and release the

1.

A U

X

button on the

transmitter.

The parking lights flash one time to confirm that valet -take-over has been

initiated Then wait a few seconds.

Turn the ignition key to the Off position (The engine remains running).

2.

Exit the vehicle and lock the system with the remote.

3.

The engine runs until the pre-programmed time elapses or a shut-down

input is received.

Note: To enable valet take-over with a manual transmission, open the door

when going into MTS mode. The parking lights flash five-times to confirm entry

into valet takeover. After you exit the vehicle you can lock the system with the

remote and the car remains running. If the vehicle shuts down when locking,

then the unit did not enter the valet take-over mode.

Advertising