Rice Lake 820i Programmable Indicator/Controller - Panel Mount Enclosure Installation Instructions - Manual

January 2007 95304
820i ™ Programmable HMI Indicator/Controller
Panel Mount Enclosure Installation Instructions
PNs 93424 and 93425
This document contains drawings, replacement parts
lists, and instructions for installing panel mount
models of
820i indicators. See the 820i Installation
Manual, PN 93018, for general installation and
configuration and calibration information.
The 820i has no on/off switch. Before
opening the unit, ensure the power cord
is disconnected from the power outlet.
• Use a wrist strap to ground yourself and protect
components from electrostatic discharge (ESD) when
working inside the indicator enclosure.
• This unit uses double pole/neutral fusing which could
create an electric shock hazard. Procedures requiring
work inside the indicator must be performed by
qualified service personnel only.
• The supply cord serves as the power disconnect for the
820i . The power outlet supplying the indicator must be
installed near the unit and be easily accessible.
Figure 1. Panel Cutout for Panel Mount Enclosure
PANEL CUTOUT
(DASHED LINE)
INTERIOR HOUSING
(DOTTED LINE)
8.02"
9.16"
11.56"
10.51"
OUTER PERIMETER OF
EXTERIOR FACEPLATE
(SOLID LINE)
To be the best by every measure