Sage Citrus Press 800CPUK - Manual (Page 12)

11
oPeRatIng yoUR neW aPPlIanCe
7. Remove the used fruit from the
juicing cone. Empty excess pulp
and seeds from stainless steel filter
as required. Repeat Steps 3–7 to
continue juicing.
note
The stainless steel filter should be
emptied when full with pulp and
seeds. The filter can be emptied
during juicing by turning the citrus
press OFF at the ON/OFF button and
carefully removing the juicing cone
and filter. Clean and replace stainless
steel filter and juicing cone before
continuing to juice. Do not allow the
stainless steel filter to overfill as this
may prevent correct operation or
damage the unit.
5. Grasp the soft grip handle and
slowly lower the juice press arm
and press down firmly until the fruit
dome is in contact with the fruit
skin. The motor will automatically
start and the juicing cone will begin
to rotate. The juice will be extracted
from the fruit and flow through the
juice spout into the glass. The pulp
and seeds will collect in the stainless
steel filter.
6. The Citrus Press juices very quickly
so each fruit half will be juiced in a
few seconds. To automatically
stop the motor, lift the juice press
arm up and backwards to its
extended position.