Sage Nutri Juicer Pro BJE820UK - Manual (Page 19)

18
oPEratIng yoUr nEW aPPlIanCE
USIng tHE PUrEE ExtraCtor
When using the puree extractor puree will
flow into the juice jug. There will be no pulp
extracted into pulp container.
notE 1
SELF-RESET OVERHEATING
PROTECTION
The Sage™ by Heston Blumenthal‰
juice processor also fitted with a
self-resetting safety device which
safeguards against overheating on
the motor with excessive loads. If
overheating occurs, the juicer will
automatically activate the overheating
protection device and the motor
will switch itself off. If this occurs,
the light surrounding the START/
STOP button will flash red. When the
overheating protection is activated,
unplug the juicer from power outlet
for at least 15 minutes to allow the
unit to cool. Then plug juicer into the
power outlet and use as normal.
notE 2
ELECTRONIC PROTECTION
The Sage™ by Heston Blumenthal‰
juice processor will automatically stop
operating if the motor is stalled. This
is an electronic safety feature. Either
too much food is being processed at
one time or the pieces are not small
enough. Try trimming food, cutting
food into smaller pieces of even size
and/or processing a smaller amount
per batch. If this occurs, the light
surrounding the START/STOP button
will flash red. To continue juicing, turn
the power OFF at the power outlet,
clear the feed chute, finally turn the
appliance back on by pressing the
START/STOP button to ON.
notE 3
OVERLOAD PROTECTION BUTTON
The Sage™ by Heston Blumenthal‰
juice processor is fitted with a safety
device which safeguards against
overloading with excessive loads. If
this occurs, juicer will automatically
activate the overload protection
button and the unit will switch
itself off.
If this occurs turn the power OFF at
the power outlet and allow the unit
to cool. Then press the overload
protection button found on the bottom
of the motor base. The safety device
will then be reset and the Sage™ by
Heston Blumenthal‰ juice processor
is ready for use again.