SINGER EXPERT FINISH - Manual (Page 5)

8 9
Vertical Burst of Steam
This feature enables you to remove wrinkles from hanging garments (jackets,
coats, shirts), hanging curtains, or other hanging fabric.
Follow the instructions as described in the “Steam Ironing” section. •
hold the iron upright, 6-12 inches away from the garment. •
press the Burst of Steam button to direct steam at the area. •
Steam will penetrate into the garment, removing the wrinkles. •
For stubborn wrinkles, wait 4 to 5 seconds before pressing the Burst of •
Steam button again. most wrinkles can be removed within three bursts.
NOTE: maintain a distance of 6-12 inches from delicate fabric (synthetics, silk,
velvet, etc.), otherwise the fabric could be damaged.
It may be necessary to press the Burst of Steam button a few times to start this
function. For optimum steam quality, do not operate the Burst of Steam more
than three times in succession.
burst of steam
Steam Ironing
Fill the water tank as described in “Filling the Water Tank” section. •
plug the iron into a grounded electrical outlet. •
The LCD Display will show all symbols and then turn off with an audible beep •
sound.
Select the desired temperature using the Temperature Up and DOWN •
buttons. The recommended steam temperature setting is from 5 to 9.
When the selected temperature is reached, the LCD Display will stop flashing •
and an audible beep will sound.
move the variable Steam Control Dial to the position. Steam will vary with •
the temperature setting. The iron is ready to use.
TIP: The tougher the wrinkle, the more steam you will need.
WARNING: NEvEr IrON Or STEAm CLOThES WhILE ThEY ArE BEINg
WOrN. NEvEr DIrECT ThE STEAm JET AT pEOpLE Or ANImALS.
Burst of Steam
This function is ideal for removing stubborn wrinkles or pressing extra-sharp
creases.
WARNING: NEvEr IrON Or STEAm CLOThES WhILE ThEY ArE BEINg
WOrN. NEvEr DIrECT ThE STEAm JET AT pEOpLE Or ANImALS.
Follow the instructions as described in the “Steam Ironing” section. •
While steam ironing, press the Burst of Steam button every 4 to 5 •
seconds. most wrinkles can be removed within three bursts.
NOTE: It may be necessary to press the Burst of Steam button a few times to
start this function. For optimum steam quality, do not operate the Burst of Steam
more than three times in succession.
Burst of Steam Button vertical burst of steam
WARNING: NEvEr IrON Or STEAm CLOThES WhILE ThEY ArE BEINg
WOrN. NEvEr DIrECT ThE STEAm JET AT pEOpLE Or ANImALS.
IRONING YOuR GARMENTS
Dry Ironing
To iron without steam, turn the variable Steam Control Dial to the “no steam” •
position .
plug the iron into a grounded electrical outlet. •
The LCD Display will show all symbols and then turn off with an audible beep •
sound.
Select the desired temperature using the Temperature Up and DOWN •
buttons.
When temperature is reached, the LCD Display will stop flashing and an •
audible beep will sound.
To iron garments with a dry iron, SINgEr recommends using this iron with an •
empty water tank.