SINGER EXPERT FINISH II - Manual (Page 4)

4
OPERATING INSTRUCTIONS
Before First Use
• Remove any protective films or stickers from the soleplate and the iron.
• Read all safety and operating instructions.
• Fill the water tank as described in the “Filling the Water Tank” section.
• To turn the iron on, plug into a grounded electrical outlet. An audible beep
sound will indicate the iron is on. The LCD Display will illuminate and the
will begin to flash.
• To begin heating, press the Temperature UP (+) button. The LCD Display will
begin to flash HEATING and will indicate the temperature setting. An audible
beep sound will indicate that the temperature is being adjusted.
• Select the maximum temperature by pressing the Temperature UP (+) button
until the display indicates MAX ••• 200º C.
• When the selected temperature is reached, HEATING on the LCD Display will
stop flashing and disappear, indicating that the iron is ready to use.
• Press the Steam Adjust Button located above the LCD Display to activate the
steam setting . An audible beep will sound.
• On an ironing board or protected surface, iron an old towel or other heavy
material until the water tank is empty and no more steam is produced.
• It is normal for a small amount of smoke and a light odor to be produced the
first time the iron is used. This will disappear quickly.
• Particles may emit from the iron the first time it is used. They are not harmful
and should disappear after the iron has been used as described above.
• Consult the garment’s label for temperature instructions or use the chart on
page 6 of this manual for recommendations.