SleuthGear Xtreme Life Outdoor Quick Guide - Manual

Quick Setup guide for Xtreme Life™ Outdoor
For best use see the complete manual located on included CD
Step 1: Charge Xtreme Life™ DVR for 18 hours before initial use.
Step 2: Remove Switch Cover located on the exterior side of the DVR to gain access to switch settings.
Step 3: To Enable recording use the switches, move either switch 1-4 to the down position to set the re-
cording dwell time. Recording dwell time refers to how long the DVR will record once the PIR sensor has
been triggered. Note, the DVR will record continuously as long as motion remains present, otherwise it
will record for the length of time designated by the switch. (see figure 4 found on page 3 in manual).
Step 4: Enable PIR Sensitivity. Using the switches, move either switch 5-7 to the down position to set
the desired sensitivity. It is recommend users use the highest sensitivity first, making adjustments to a
lower sensitivity as needed.
Step 5: Insert your SD Card into the slot located next to the switches. (see figure 4 in manual)
Step 6: Position your camera in it’s desired recording location.
Step 7: Power on your Xtreme Life™ DVR by pressing the power button located on the front panel of the
DVR. (see figure 6 in manual)
Accessing Main Menu
Connect the supplied video output cables to the AV Output connector located on the exterior side of the
DVR (see figure 4 in manual). Move switch 8 to the down position, all other switches to the up position.
Connect the Video Output cables to a Television or Monitor. Then press the setup button on your remote
to display main menu.
E0125
Quick Setup guide for Xtreme Life™ Outdoor
For best use see the complete manual located on included CD
Step 1: Charge Xtreme Life™ DVR for 18 hours before initial use.
Step 2: Remove Switch Cover located on the exterior side of the DVR to gain access to switch settings.
Step 3: To Enable recording use the switches, move either switch 1-4 to the down position to set the re-
cording dwell time. Recording dwell time refers to how long the DVR will record once the PIR sensor has
been triggered. Note, the DVR will record continuously as long as motion remains present, otherwise it
will record for the length of time designated by the switch. (see figure 4 found on page 3 in manual).
Step 4: Enable PIR Sensitivity. Using the switches, move either switch 5-7 to the down position to set
the desired sensitivity. It is recommend users use the highest sensitivity first, making adjustments to a
lower sensitivity as needed.
Step 5: Insert your SD Card into the slot located next to the switches. (see figure 4 in manual)
Step 6: Position your camera in it’s desired recording location.
Step 7: Power on your Xtreme Life™ DVR by pressing the power button located on the front panel of the
DVR. (see figure 6 in manual)
Accessing Main Menu
Connect the supplied video output cables to the AV Output connector located on the exterior side of the
DVR (see figure 4 in manual). Move switch 8 to the down position, all other switches to the up position.
Connect the Video Output cables to a Television or Monitor. Then press the setup button on your remote
to display main menu.
E0125