Installation of tbf – Smart Power Systems Copier Guardian User Manual

Page 3

Advertising
background image

1.Turn off and un-plug equipment to be protected from wall outlet.
2. Plug the equipment into the Copier Guardian II

.

3. Plug the Copier Guardian II unit into grounded wall outlet.
4. Your equipment is now fully protected. Place the Copier Guardian II where monitoring lights can
be observed.

Unit

INSTALLATION OF TBF™

Use the Standard CAT 5 Network Patch cord when using the Network protection RJ45 circuit.

Connected

Equipment with

Tel./Modem Jack

Power Cord

Power Cord

Pigtail
Outlet

Copier Guardian

Power Cord

Phone Cord

Phone Cord

Network Cord

Network Cord

LINE

LINE

DEVICE

DEVICE

Phone

Wall Jack

Network Jack/ HUB

Connected

Equipment with

Network Jack

Installation for Protection for Telephone Line and Network Cable

TELEPHONE
1. Unplug the equipment's telephone cable from the wall jack and plug into the RJ11 "DEVICE" on
the Copier Guardian II.
2. Plug the provided telephone cable to the RJ11 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the telephone cable into the RJ11 wall jack.

Telephone Line Protection clamping voltage 250-350 vdc.

NETWORK
1. Unplug the equipment's network cable from the wall RJ45 network jack and plug into the RJ45
"DEVICE" on the Copier Guardian II.
2. Plug the provided network cable to the RJ45 jack "LINE" on the Copier Guardian II.
3. Plug the other end of the network cable into the wall RJ45 network jack. Your equipment is now
fully protected. Place the Copier Guardian II where monitoring lights can be observed.

NOTE: All Copier Guardian II units come with security straps,

warning label and Velcro™ to secure unit to connected equipment.

STRAP FOR RECEPTACLE

STRAP FOR PIGTAIL

RECEPTACLE

The label on the security

strap is permanent and

warning: to unplug the unit

will cause the label to tear

out and void the warranty.

IMPORTANT: Velcro™ strips are provided so
Copier Guardian II can be attached to copier
when needed. Do not place Velcro™ over label.

BACK OF UNIT

Provided with

Velcro™ strips

CAUTION: - Never install telephone wiring during a lightning storm.
- Disconnect telephone line at the network interface before installing the secondary
protector.
- Intended for indoor use only.

The GREEN light confirms properly the connected equipment is fully protected. The RED light
indicates over voltage, improper ground connection or reversed power wires which needs to
be corrected. In an over voltage incident, power is disconnected to protect the connected
equipment. IMPORTANT: If the RED Light comes on, contact your electrician to inspect
and correct the outlet wiring in order to receive the maximum protection for your connected
equipment.

Advertising