Snow Joe TJ600E Tiller Joe 6.5 AMP Electric Garden Tiller/Cultivator - Manual (Page 9)

9
Powering ON and OFF
Note: Before starting the electric tiller do the following:
l Ensure the tines are not touching any objects.
l Hold the grips firmly with both hands.
1. Turn ON the machine by pressing the Safety Button (B)
(See Fig. 7) and the squeezing Power Switch (C) (See
Fig. 7). Release the Safety Button (B) (See Fig. 7).
Note: The tines will begin to rotate and dig themselves
into the ground.
2. After completing the work release Power Switch (C) (See
Fig. 7)to turn the machine OFF.
Operating the Electric Tiller
1. Walk the electric tiller through the soil at a normal pace
and in as straight a line as possible.
2. Always till away from the electrical outlet. Ensure the
extension cord is kept away from the work area.
3. Do not try to till to deeply or force the electric tiller into
soil that is extremely hard or resistant.
Note: Overloading the machine will cause it to shut
down. If this occurs the machine will not operate until the
motor has completely cooled down.
4. Always maintain a firm grip on the electric tiller.
5. Lift the electric tiller over hard surfaces. Do not lift or
drag the electric tiller when the motor is running.
Cleaning, Maintenance and
Storage
Important!
l Wear protective gloves when cleaning or maintaining
the machine.
l Do not use cleaning fluids or solvents or spray the machine
down with water (especially water under pressure) when
cleaning the machine.
After each use, follow these steps when cleaning the machine:
1. Remove soil, dirt and foliage stuck in the tines,
driveshaft, tool surface and vents with a brush or
dry cloth.
2. Spray or rub biodegradable oil into the tines.
3. Clean soiled grips with a damp cloth.
Always inspect the machine for damaged and worn parts
after each use. Check that safety features (labels, guards)
are in place. Check that nuts, bolts and screws are tight.
WARNING
m m
Unexpected tines movement may cause personal injury.
Before servicing, repairing or inspecting the tiller, turn
the motor OFF and disconnect the extension cord. Wait
for the tines to completely stop rotating before conducting
inspection, cleaning or maintenance.
WARNING
m m
Contact with hot components (i.e.: motor housing,
gear box) on the machine may cause burns. Allow
the machine to cool off before handling.
WARNING
m m
Rotating tines may cause serious injury. The tines will
continue to turn for a few seconds after the tool has
been switched OFF. Do not touch the rotating tines.
Contact with hot components (i.e.: motor housing,
gear box) on the machine may cause burns. Allow
the machine to cool off before handling.