Snow Joe SDJ616 Shredder Joe 13-Amp 16:1 Reduction Electric Leaf Mulcher/Shredder - Manual (Page 6)

6
Assembly
m
WARNING!
Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and serious personal injury.
m
CAUTION!
Carefully unpack the components of
the box and verify that all parts are intact. Do not separate
the parts by force. If any part is broken, please contact an
authorized service agent.
Unpacking
1. Open the box.
2. Take out the funnel assembly and the three legs.
3. Remove the motor bracket from the funnel.
Assembling the Mulcher Stand
1. Loosen the height adjustment knob on the leg and pull the
tube to the desired height; tighten the knob to secure the
leg in place (Figs. 4 & 5).
2. With your finger pressed against the leg pin indicated in
Fig. 6, insert the leg into the hole on the motor housing
assembly. Let the pin slip into the hole to secure the leg
in place. Repeat with the two other legs until the two
remaining holes on the housing assembly are properly
fitted.
Fig. 1
Fig. 2
Cover plate Motor bracket Funnel
Fig. 3
Fig. 4
Fig. 5
Fig. 6