Snow Joe SJ624E Ultra 21-Inch 14-Amp Electric Snow Thrower - Manual (Page 14)

13
Replacing the Pulley
1. Open the left side plate by removing three screws.
(Fig. 26). Remove the belt following the directions
above (Fig. 30)
2. Secure the auger. Using an 18 mm hex socket, turn the
pulley clockwise to remove (Fig. 31).
3. Follow directions in reverse to install new pulley.
Storage
1. Allow the engine to cool completely before
cleaning, storing or transporting the snow thrower.
Be sure to secure the unit while transporting.
2. Disconnect the extension cord from the snow thrower.
Inspect the extension cord closely for signs of wear or
damage. Replace it if it is worn or damaged.
3. Inspect the snow thrower carefully for worn, loose or
damaged parts. Check connections and screws and
tighten if necessary. For repairing or replacing parts,
contact your authorized Snow Joe ® + Sun Joe ® dealer
or the Snow Joe ® + Sun Joe ® customer service center at
1-866-SNOWJOE (1-866-766-9563).
4. Store the unit, along with the disconnected extension
cord, in a locked, dry place out of the reach of children to
prevent unauthorized use or damage. Cover loosely with a
tarp for added protection.
Service and Support
If your Snow Joe ® Ultra SJ624E electric snow thrower requires
service or maintenance, please call 1-866-SNOWJOE
(1-866-766-9563) for assistance.
Model and Serial Numbers
When contacting the company, reordering parts or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
on the main cover of the unit to the left of the discharge chute.
Copy these numbers into the space provided below.
Fig. 30
Fig. 31
Record the following numbers from the housing or handle of your
new product:
Model #:
Serial #:
S J 6 2 4 E