Snow Joe 323E Plus 13-Inch 10-Amp Electric Snow Shovel - Manual (Page 11)

11
7. Replace the worn belt with a new belt, then screw the
motor support back into position (Fig. 24).
8. Reattach the upper housing to the lower housing by
replacing all housing screws (Fig. 19).
9. Place the left side cover back into position and refasten
the five (5) screws.
10. Place the right side cover back into positon and refasten
the five (5) screws.
Replacing the Scraper Blade
m
WARNING! Disconnect the power from the electric
snow shovel before performing this task.
1. Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper blade to the base
of the unit (Fig. 25).
2. Remove the old scraper blade (Fig. 26).
3. Install the new scraper blade and fasten it securely to the
housing with the four (4) screws (Fig. 27).
Lubricating the Electric Snow Shovel
This electric snow shovel does not need lubrication. All
bearings are lubricated at the factory for the life of the product.
Fig. 23
Belt
Motor
support
Fig. 24
Belt
Motor support
Fig. 25
4 screws
Drill
Fig. 26
Scraper blade
Fig. 27
Scraper blade
4 screws