Chute crank assembly – Snow Joe SJ620-RM Ultra 18-Inch 13.5-Amp Electric Snow Thrower User Manual
Page 6
Advertising
6
2. Lift the chute deflector and lock securely onto the
discharge chute (Fig. 6).
3. Raise or lower the chute deflector to the desired height of
the snow stream and tighten the knobs (Fig. 7).
Note: Do not over tighten the knobs.
Chute Crank Assembly
1. Slide the upper chute crank through the rubber ring
located on the middle frame (Fig. 8).
2. Loosen the screw on the lower chute crank by hand
(Fig. 9).
3. Slide the upper chute crank into the lower chute crank
(Fig. 10).
4. Align the screw holes and tighten the screw by hand
(Fig. 11).
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Advertising
This manual is related to the following products: