Thetford 1200 Series Water Dispenser - Manual (Page 7)

Owner’s Manual 7
Installation Instructions
NOTE: The doors are made to accept decorative panels. The
decorative panels must be 3/16 inch or less in
thickness. Install the decorative door panels in the
refrigerator doors before installing the refrigerator in
the vehicle.
1. Make two upper door panels that are 16 13/64 inches wide x
18 3/8 inches high:
- Raised panels must be centered on each door and no
larger than 15 11/32 inches wide x 17 17/32 inches high.
2. Make a lower RH door panels that is 16 13/64 inches wide x
41 13/64 inches high:
- Raised panels must be centered on the lower RH door and
no larger than 15 11/32 inches wide x 40 11/32 inches high.
3. Make a lower LH door panel that is 16 13/64 inches wide x
34 13/64 inches high:
- Raised panels must be centered on the lower LH door and
no larger than 15 11/32 inches wide x 33 37/64 inches high.
4. Install the decorative door panels:
- Pull the panel retainer [1] off of each door [2] (See Art01712).
- Push a decorative door panel [3] into the slots of each door.
- Make sure that each panel retainer is correctly positioned
and push the curved snap [4] of the panel retainer [5] inside
of the curved snap [6] of the door (See Art01648).
- Make sure that the decorative door panel [3] of the lower LH
refrigerator door is behind the water dispenser panel [7].
Install Decorative Door Panels (non-metal
door models)
1. Install the back splash assembly (See Art01710):
- Put the hook on the bottom of the back splash assembly [4]
down into the slot [5] of the water dispenser panel [2].
- Align the two (2) rectangular mounting studs on the rear of
the back splash assembly with the two (2) mounting lugs
[6] on the water dispenser panel.
- Using equal pressure, push both mounting studs into the
mounting lugs at the same time.
- The mounting studs should engage and lock into the
mounting lugs with a “click” sound.
Install the Water Dispenser Components
(non-metal door models)
1. Install the back splash assembly (See Art01710):
- Put the hook on the bottom of the back splash assembly [4]
down into the slot [5] of the water dispenser panel [2].
- Align the two (2) rectangular mounting studs on the rear of
the back splash assembly with the two (2) mounting lugs
[6] on the water dispenser panel.
- Using equal pressure, push both mounting studs into the
mounting lugs at the same time.
- The mounting studs should engage and lock into the
mounting lugs with a “click” sound.
Install the Water Dispenser Components
(metal door models)