Thetford 1210 Series Water Dispenser - Manual (Page 7)

Owner’s Manual 7
Installation Instructions
NOTE: The doors are made to accept decorative panels. The decorative panels
must be 3/16 inch or less in thickness. Install the decorative door
panels in the refrigerator doors before installing the refrigerator in the
vehicle.
1. Make two upper door panels that are 16 13/64 inches wide x 18 3/8 inches
high:
- Raised panels must be centered on each door and no larger than 15 11/32
inches wide x 17 17/32 inches high.
2. Make a lower RH door panels that is 16 13/64 inches wide x 41 13/64 inches
high:
- Raised panels must be centered on the lower RH door and no larger than 15
11/32 inches wide x 40 11/32 inches high.
Install Decorative Door Panels (non-metal door models)
1. Install the back splash assembly (See Art01795):
- Put the hook on the bottom of the back splash assembly [4]
down into the slot [5] of the water dispenser panel [2].
- Align the two (2) rectangular mounting studs on the rear of the
back splash assembly with the two (2) mounting lugs [6] on
the water dispenser panel.
- Using equal pressure, push both mounting studs into the
mounting lugs at the same time.
- The mounting studs should engage and lock into the
mounting lugs with a “click” sound.
Install the Water Dispenser Components (non-
metal door models)
1. Install the back splash assembly (See Art01795):
- Put the hook on the bottom of the back splash assembly [4]
down into the slot [5] of the water dispenser panel [2].
- Align the two (2) rectangular mounting studs on the rear of the back splash assembly with the two (2) mounting lugs [6] on the
water dispenser panel.
- Using equal pressure, push both mounting studs into the mounting lugs at the same time.
- The mounting studs should engage and lock into the mounting lugs with a “click” sound.
Install the Water Dispenser Components
(metal door models)
Art01795
6
4
5
37
125
126
Art01794