Clarion DXZ466MP - Manual (Page 22)

22
English
DXZ466MP
• Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft. When the DCP is removed from the
unit, this indicator blinks.
∗
The factory default setting is “OFF”.
2-1. Select “ BLINK LED”.
3-1. Turn the [ROTARY] knob to select “ON” or
“OFF”.
• Setting the external amplifier
∗ The factory default setting is “OFF”.
2-1. Select “ AMP CANCEL”.
3-1. Turn the [ROTARY] knob to select “ON” or
“OFF”.
Operations Common to Each Mode
• Triggered audio mute for cellular
telephones
This unit requires special wiring to mute the audio
signal automatically when a cellular telephone
rings in the car.
∗ This function is not compatible with all cellular
telephones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
• Performing a system check
This function allows you to perform a system check
from the adjust mode when required.
2-1. Select “
SYSTEM CHECK ”.
3-1. Press and hold the [ ] button for 1 second
or longer.
“SYSTEM CHECK” appears in the display,
then the unit returns to the previous
operation mode.
To change other settings
1. Press the [ADJ] button to switch to the
adjustment selection display.
2. Press the [ , ] lever upward or down-
ward to select the “item name”.
Each time the [ , ] lever is pressed
up/down, the item display changes in the
following order:
“BLINK LED” “AMP CANCEL”
“AUX SENS” “SYSTEM CHECK ”
3. Turn the [ROTARY] knob to select the “desired
setting item”.
∗ After completing settings, press the [ADJ] but-
ton to return to the previous mode.
• ON:
Use with connected AMP.
• Selecting AUX IN sensitivity
Make the following settings to select the sensi-
tivity when sounds from external devices con-
nected to this unit are difficult to hear even after
adjusting the volume.
∗ The factory default setting is “MID”.
2-1. Select “ AUX SENS”.
3-1. Turn the [ROTARY] knob to select “LOW”,
“MID” or “HIGH”.
• Adjusting the display scroll speed
This feature allows you to slow down the scroll
speed when the scroll speed is too fast, making it
difficult to view the screen.
∗
The factory default setting is “SPEED 3”
2-1. Select “ SCRL SPEED”.
3-1.Turn the [ROTARY] knob to select the setting.
∗ This setting item can be adjusted within the
range SPEED 1 to SPEED 6.
Adjust this setting item while viewing how the
appearance of the display changes.
• Dimmer control
You can setting the dimmer control “ON” or “OFF”.
∗
The factory default setting is “ON”.
2-1. Select “ DIMMER”.
3-1. Turn the [ROTARY] knob to select “ON” or
“OFF”.
• Adjusting the display contrast
You can adjust the display contrast to match the
angle of installation of the unit.
∗
The factory default setting is “08”.
(Adjustment level: 01 to 16)
2-1. Select “ CONTRAST”.
3-1. Turn the [ROTARY] knob to adjust the
contrast.
Push ENT
• OFF:
Use with inside AMP.
Push ENT