Ignition - propane gas operation (n510 models) – Thetford N400 Series Installation Manual User Manual
Page 10
Installation Manual 10
Ignition - propane gas operation (N510 models):
Press the ON / OFF button [1] to start the refrigerator in auto
mode.
- Push and hold the MODE button [4] until the light bar
flashes in the center display beside LP GAS [7].
- Release the MODE button.
NOTE: On initial start up of the refrigerator, ignition of the
propane gas may not occur within 30 seconds.
If ignition of the propane gas does not occur within 30 seconds:
- The gas safety valve of the refrigerator closes.
- The refrigerator stops operation.
- Refer to the “Fault Codes“ section of this manual.
- The fault code remains until you push the ON / OFF button
two times (to stop and start the refrigerator).
- If ignition does not occur after two or three times:
- Check the gas supply line.
- Consult your local dealer or an authorized Norcold
Service Center.
- Change to manual mode and operate on AC electric.