Torbal RXP-4 - Manual (Page 3)

Parts Description Parts Description
On/Off switch RS232C Port Paper feed button
AC Adaptor socket Power indicator
Printer Cable RS232C DIN 6 (Plugs
into the Printer) RS232 (Plugs into
the Scale)
AC Adaptor
Getting Started Getting Started
Remove the printer and all of its
components from the packaging
and place them on a stable base
near the scale. 1.
2
Inserting and replacing the paper roll Inserting and replacing the paper roll
5
Before you begin inserting the new
paper roll into the printer, use scissors
to cut off the corners of the paper
approximately 1 inch from each side as
shown. This will allow you to easily
insert the new roll. 1.
Once the paper has been prepared,
remove the printer cover by lifting it
upwards. 2.
You may now insert the paper into the
paper slot as shown below. Once the
tip of the paper is in the slot, press the
feed button until the paper goes
through. The paper roll should then be
placed in the printer and the cover put
back in place. 3.