Tycon Power TP-BC12-300 - Manual (Page 5)

NOTICE:
1. DON’T CONNECT THE PS TO 24V BATTERY. The PS was designed for 12V
system. Connection to the wrong battery will damage the PS.
2. THE AC SWITCH MUST BE TURNED OFF AT ANY TIME WHEN THE
BATTERY IS CHANGED.
3. Select the correct battery type on the panel, wrong selection will damage the
battery or it will not fully charge the battery. Do not change the battery type
selector when charging.
4. The model has a 6 amp AC input fuse inside of the unit. To replace the fuse you
should remove the old fuse by opening the case and replace it with a new 6 amp
fuse.
5. The cables for battery connection or device to the PS should be 14AWG min.
Please keeping the connect points clean to avoid spark or electrical leakage.
6. Use the proper voltage solar panel or wind turbine for the connection, no voltage
of over 18V.
7. When connecting a solar panel or wind turbine controller to the PS, please make
sure of the correct polarity.