Vetter Ultra Flat Bags 8 bar (116 psi) - Manual (Page 6)

Vetter Ultra Flat Bags 8.0 bar
Page 5/16
Pos. Article No. Description
7 1600 0087 00 Hand pump (7)
7
8
8 1600 0094 00 Foot pump (8)
2.3 The Vetter safety coupling system
a. Inlet coupling controller
Connect the air supply hose, resp. connection hose of the pressure re-
ducer, to the plug nipple of the inlet coupling on the controller. In doing
this, firmly press the nipple into the coupling until it latches in. Turn the
brass sleeve of the coupling opposite to the safety pin for additional sa-
fety.
b. 8 bar inflation coupling
Firmly press the hose, resp. bag nipple, into the coupling until it latches
in order to connect the inflation hose with the corresponding controller,
resp. with the Ultra Flat Bag. The coupling sleeve must lay on the support
ring without any gap (1). The nipple must be firmly pressed against the
spring pressure in the coupling in order to release the connection (only
in pressure-free condition). At the same time, the coupling sleeve must
be pulled back. The connection is then released.
1
1
2
3