Vetter Ultra Flat Bags STec 10 bar (145 psi) - Manual (Page 4)

Vetter Ultra Flat Bags S.Tec 10 bar
Page 3/15
Additional information for illuminated control element
Air CU 10 bar Totmann lighting
The lighting of the control element illuminates all couplings,
switch levers and manometers. It is switched on and off with
switch (1) on the side.
The control element is supplied by a 9 V block battery. Since the
entire lifting bag system is designed for a temperature range of
-20 °C to +55 °C, only batteries with this temperature range are
allowed to be used. Based on the current state of the art, only li-
thium batteries meet this requirement.
To insert the battery, unscrew the battery compartment, replace
the old battery with a new one and screw the battery compart-
ment back together.
Control elements with lighting come under the German Law on
electrical and electronic devices (ElektroG) of 24 March 2005 for
implementation of the EC Directive 2002/96/EC on electrical and
electronic waste – WEEE Directive.
The label attached to the battery compartment cover points
out that the electronic components in this product must not be
handled as domestic waste; they have to be returned to the ma-
nufacturer (return freight paid) for recycling.
d. Dual controller 10 bar with dead-man switching,
aluminium
Press the lower button (1) in order to inflate the bag. After release,
the press-button returns again to the zero position and interrupts
the inflation sequence. Press the upper button (2) in order to de-
flate.
e. Single controller 10 bar with dead-man switching,
aluminium
If only one Ultra Flat Bag S.Tec is used for operation then this can
be controlled with a single controller.
Inventory check
On acceptance of the Ultra Flat Bags S.Tec equipment a check is to
be made to see if the delivery is complete according to the delive-
ry note. In addition to this a visual check and function test is to be
made according to the operating instructions.
2
1
1
Different couplings!