Vinten Radamec Fusion FHR-145 - Manual (Page 12)

10
FHR-35 Robotic Pan and Tilt Head
Installation
Adjusting the Camera Cradle
Installation Guide
2. Adjusting the mounting plate
(B) Stepped adjustment – Adjust the mounting
plate by removing the two side screws and
washers and moving the plate to the required
attachment point on the side of the backplate.
Reattach using the screws and washers.
(C) Slide adjustment – Loosen the two
mounting plate side screws enough to
adjust the plate by sliding it up or down.
Ensure the side screws are securely
tightened before mounting the payload.
(A)
(B)
(C)
FH/FHR-145 Pan and Tilt Head
Note: Loosen the jacking screw
before adjusting the height of the
mounting plate (see page 11).
1. Adjusting the backplate
(A) Stepped adjustment –
Using a 5 mm Allen
key, remove the three
centre screws and pull
the camera cradle off
the tilt mounting.
Reposition the cradle
as desired, then
reattach using the
centre screws.
If necessary, remove
the mounting plate.