Voltage Valet BH2 - Manual

ONE YEAR WARANTY
We guarantee each new Beverage Heater to be free
from defects in material or workmanship and to
perform under normal use and service. This
guarantee shall run for a period of one year from
the date of purchase, and obligations under this
guarantee are limited to remedying any defect or
replacing any defective part and shall be effective
only if the defective unit is returned to us within 12
months after purchase. Damage due to abuse, misuse,
or overloading is not covered by this guarantee. We
shall not be responsible for any other loss or damage
that may arise through the use by a purchaser or
others of this device, and the purchaser assumes such
responsibility and will hold Hybrinetics, Inc. harmless
in respect to all such loss or damage.
Important: Important: This is a factory direct warranty. Do not
return defectives to your retailer. All defectives must
be returned to the factory accompanied by a sales
receipt with the original date of purchase. For more
information please call our toll free number:
(800) 247-6900.
Voltage Valet Division, Hybrinetics, Inc. Voltage Valet Division, Hybrinetics, Inc.
225 Sutton Place, Santa Rosa, CA 95407
e-mail: hybrinet @ voltagevalet.com
www.voltagevalet.com
© 2005 Hybrinetics,Inc.
IMPORTANT SAFEGUARDS
When using electrical appliances, especially when children
are present, basic safety precautions should always be
followed including the following:
READ ALL INSTRUCTIONS BEFORE USE READ ALL INSTRUCTIONS BEFORE USE
DANGER DANGER - The Beverage Heater’s heating element
becomes very HOT. Do not touch the hot element. Use
the handle.
To reduce the risk of death by electrical shock:
1. Always unplug the beverage heater
immediately after using.
2. Do not use while bathing.
3. Do not place or store this appliance where
it can fall or be pulled into a tub or sink.
4. Do not immerse the handle or cord into
water or other liquid at any time.
5. If an appliance falls into water, unplug it
immediately. Do not reach into the water.
HOUSEHOLD USE ONLY
WARNING WARNING - To reduce the risk of burns, electrocution,
fire or injury to persons:
1. An appliance should never be left unattended when
plugged in.
2. Close supervision is necessary when this appliance is
used by, on, or near children or invalids.
3. Use this appliance only for its intended
use as described in this manual. Do not use
attachments not recommended by the manufacturer.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working properly,
if it has been dropped or damaged, or immersed in
water. Return the appliance to a service center for
examination and repair.
5. Keep the cord away from heated surfaces. Do not
allow cord to touch hot heating coil.
6. Do not let the cord hang over edge of table or
counter.
7. Never use while sleeping.
8. Do not use outdoors.
9. Do not place appliance on any surface while it is
operating.
10. Do not place appliance on or near a hot gas or
electric burner, or in a heated oven.
11. Extreme caution must be used when moving a
vessel containing hot oil or other hot liquids.
12. This appliance was set at the factory to operate at
120 or 240 volts.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
WARNING: WARNING: Do not plug beverage heater into electrical
outlet unless heating coil is immersed in liquid. Unplug
beverage heater from electrical outlet before removing
heating coil from liquid.
NOTE:
NOTE: The Beverage Heater includes a burn shield that
will protect countertops if heating coil is hot when
placed on a counter surface.The beverage heater may be
operated with the burn shield in place or removed.
See Fig. 1
1. Insert heating coil into liquid. The liquid level must
be above the round part of the heating coil and
below the black handle.
2. Do not immerse the handle or cord into the liquid
at any time.
3. Plug beverage heater into electrical outlet.
4. Allow liquid to heat. Heating time for one cup of
water on 110/120-volt electrical service is 12–15
minutes. On 220/240-volt electrical service, it is
3–5 minutes.
5. When liquid has reached desired temperature,
remove plug from electrical outlet before removing
heating coil from liquid.
6. To avoid burns, use extreme caution when removing
heating coil from hot liquid and when moving hot
liquids.
7. To prevent possible damage, do not wrap the
electrical cord around thebeverage heater. Fold
cord loosely on the side of the beverage heater
and store in pouch.
120-240 VOLT OPERATION 120-240 VOLT OPERATION
1. This beverage heater can be operated safely on
110/120 volt North American electricity or on
220/240 volt foreign electricity.
2. Adaptor plugs needed for use in 220/240 volt
countries are not included. Ask your Voltage
Valet retailer for the correct plug for the
country you are visiting.
SPECIAL INSTRUCTIONS SPECIAL INSTRUCTIONS
A short power supply cord has been provided with
the beverage heater to reduce the hazards
resulting from becoming entangled in or tripping
over a longer cord. To avoid a circuit overload, do
not operate another high-wattage appliance at the
same time on the same circuit.
MAINTENANCE MAINTENANCE
The beverage heater may be cleaned when it has
been unplugged and has cooled, by wiping with
hot, soapy water, followed by rinsing. Do not
immerse handle in liquid when cleaning. No other
maintenance is required.
Beverage Heater
Burn Shield
FIG 1
Instruction Manual - Model BH2
50/60 Hz 120V 125W - 240V 500W
Read instructions before using this appliance
Beverage Heater
Dual Voltage