Workrite Sierra HXL Electric Assembly Instructions for 3-leg Electric Workcenters - Manual (Page 5)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5 of 8
Workrite Sierra HX & HXL Electric Workcenters - Assembly Instructions for 3-leg Tables
Attach Feet (sold separately) & Slides
Attach Feet (H) to bottom of legs with Flat Head
Cap Screws (J), using Allen Wrench (L) and tighten
securely. Be sure the longer end of the foot goes
towards the front of the table.
You may have purchased the Styled Feet, that attach
in the same fashion.
Attach Feet Glides (I) to bottom of feet. Do not screw
in all the way to allow for leveling in step 11
Attach Control Box to Tabletop
Position Control Box (O).
If you have a Workrite tabletop:
Locate the four pilot holes for the Control Box and
proceed to Step b .
If you do not have a Workrite tabletop:
Place Control Box (O) in position and use a pencil to
mark pilot hole placement. Control Box should be placed
towards rear center of tabletop. Lay out Switch (N) and
Leg Cables (P) to be sure they all reach the Control Box.
Remove Control Box and drill pilot holes where marked.
Do not drill all the way through tabletop!
With Control Box positioned over pilot holes, attach with
four Pan Head Screws (K) as shown.
J
a
b
H
5
H
I
K
6
a
b
b
a
N
O
K O