Workrite Sierra HXL Crank Assembly Instructions for 2-Leg Top Crank models - Manual (Page 7)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 7 of 8
Workrite Sierra HXL™ 2-Leg Top Crank Workcenters - Assembly Instructions
Flip table back and reposition leg assembly.
Drill pilot holes and insert screws for two
positioning holes first being sure to center the
leg over the crank handle hole. TAKE EXTRA
CARE TO NOT DRILL THROUGH TOP!
Use the other screw holes to mark the
location of the remaining holes for each leg.
Turn the worksurface over to the top finish
side and use the ¾" spade drill bit to finish
drilling the hole from the top down, to ¾"
diameter, using the ⅛" hole as a guide.
Base-Only Models & Other Tabletops: Position and Drill Hole for Top Crank
Position the leg assembly on the face-down table top. Center the assembly on the table so that
neither of the side legs overlap the edge. Measure carefully to ensure that your table will be
positioned correctly as detailed below before drilling.
Mark ¾" hole for crank handle: Trace around outside of leg bracket before removing leg assembly.
Measure from front left corner of leg bracket as shown, then mark hole placement. The hole should
be directly under the center of the leg.
Use the ⅛" drill bit to drill from the bottom of the worksurface completely through the
worksurface. DO NOT USE ¾" bit. Drill from bottom to avoid damaging top surface.
9
¾
c
c
d
d
Top of
worksurface
Bottom of
worksurface
Half the leg width
Half the leg depth
Center of leg
a
b
a b
1⅜"
1⅞"
Trace
Trace
1⅜"
1⅞"