Workrite Sierra Crank Assembly Instructions for Front and Top-Crank models - Manual (Page 10)

10 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Sierra™ Crank Workcenters - Assembly Instructions
10 ⅞ " from table
edge to mounting
hole for 30" base
versions
or
4 ⅞ " from table
edge to mounting
hole for 24" base
versions
4 ⅞ " from
table edge to
mounting hole
6
a
b
Base-Only Front-Crank models: Secure Table Base to Tabletop
For Base-Only Top-Crank models please skip to page 11.
Position the leg assembly on the face-down table top. Center the assembly on the table so that
neither of the side legs overlap the edge. Measure carefully to ensure that your table will be
positioned correctly as detailed below before drilling.
Position the Crank Handle Connector over the two holes nearest the inside of the leg. You must
be sure that the crank handle will clear the table top when extended and that there is enough
clearance in front of crank handle for crank rotation and hand clearance.
Drill the two leg holes for the Crank
Handle Connector and the two holes
in the Crank Handle. Insert these four
screws and be sure the handle turns
smoothly. Then use the other screw holes
to drill the remaining holes for each leg.
Attach the desk at all points.
Skip to Step 7 on page 12.
a
b
5
a
b
c
Front-Crank models only: Attach and Connect Crank Handle
Attach Crank Handle Connector to Leg by inserting the short end into the hole in the leg.
If you have a Workrite tabletop, secure the Crank Handle Connector to the leg and tabletop, using
two holes left empty in step 3, above.
Attach Crank Handle Assembly to Crank Handle Connector, making sure that the handle clears the
table top when extended.
For base-only models, proceed to Step 6 below.
Secure to table using four wood screws.
If you have a Workrite tabletop, proceed to step 7.
d
a
10 ⅞ " from table
edge to mounting
hole for 30" base
versions
or
4 ⅞ " from table
edge to mounting
hole for 24" base
versions
4 ⅞ " from
table edge to
mounting hole
10 ⅞ " from table
edge to mounting
hole for 30" base
versions
or
4 ⅞ " from table
edge to mounting
hole for 24" base
versions
4 ⅞ " from
table edge to
mounting hole
N
O
P
P
b
c
d
10⅞" for 30"
4⅞" for 24"
4⅞"