Workrite Series VALUE Assembly Instructions for Tables with Right Front Crank - Manual (Page 9)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 9
Sonoma Series™ VALUE Workcenters - Assembly Instructions for Tables with Right Front Crank
a
b
c
12
11
For Base-Only version: Secure Table Base to Tabletop
Position the leg assembly on the face-down table top. Center the assembly on the table so that
neither of the side legs overlap the edge. Mark the first two pilot holes to ensure that your table
will be positioned correctly as detailed below
before drilling the remaining holes.
The front right mounting hole for the crank handle
must be positioned precisely 4 ⅞ " from the abso-
lute edge of the table as shown in the diagram.
The front left mounting hole for Leg 1 must be
positioned precisely 10 ⅞ " from the absolute edge
of the tabletop as shown in the diagram if you
have a 30" base version, or 4 ⅞ " from the absolute
edge of the table if you have a 24" base version.
Be sure there is enough clearance in front of the
crank handle for crank rotation and hand clear-
ance.
Drill and insert screws for these two holes first,
then use the other screw holes to mark the loca-
tion of the remaining 28 holes. Attach the desk at
all points, but do not tighten the screws that
attach the crank handle at this time. 4 ⅞ " from
table edge to
mounting hole
10 ⅞ " from table
edge to mounting
hole for 30" base
versions
or
4 ⅞ " from table
edge to mounting
hole for 24" base
versions
a
b
c
V
V
a
b
c
Tighten Crank Handle to Desk
Push Crank Handle Assembly as close to leg as pos-
sible, ensuring clips on hex rod are flush against leg
and gear box.
While pushing on crank assembly, tighten Wood
Screws connecting bracket to desk.
Tighten screws connecting handle to desk.
Gear
box
a
b
c
Clips must
be flush
against the
leg and the
gearbox.