Workrite Fundamentals EX Electric Assembly Instructions for 2-leg Workcenters 30”–48” Wide - Manual (Page 8)

8 of 8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Workrite Fundamentals Workcenters - Assembly Instructions for 2-leg Tables, 30”–48” Wide
Initialize Legs
After all legs and the switch are connected, and the power cord has been plugged in, hold the
down arrow on the switch until the legs make a short motion down and then back up. This
initializes and synchronizes the table legs.
Adjust Feet Guides
If necessary, adjust leveling guides on table feet to level the worksurface. Unscrew to increase
height, screw in to decrease height.
10
You must complete
this initialization
step or your table
will NOT function
properly.
!
11
Cleaning instructions
To clean the Sierra HX legs, apply cleaner to a soft cloth.
Suggested cleaners: Windex or Formula 409.
Do not use solvents and do not saturate or spray cleaners directly to table base.
Hold down the down
arrow until table moves
slightly upwards
Connect Power Cord to the Power Supply and put workcenter upright
Connect the Power Cord (Q) to the Power Supply (R).
Turn the table over into an upright position.
Plug the Power Cord into the power outlet.
a b c
R
Q
b
9
a
c