Workrite Gemini Arm Platform Adaptor - Manual

WorkRite Ergonomics
1450 Technology Lane
Petaluma, CA 94954
ph: 800.959.9675
fx: 800.930.8989
www.workriteergo.com
© 2004 WorkRite Ergonomics, Inc. All Rights Reserved
Gemini Arm Platform Adaptor
Model# UB-04933 Fits 2420-20/2440-20
Model# UB-04985 Fits 2420-23/2440-23
Model# UB-04986 Fits 2420-27/2440-27
INSTALLATION INSTRUCTIONS
1
Install Gemini Arm
Install the Gemini Arm to your
workstation as shown in the
Gemini Arm Installation
Instructions.
Attach the T-Pull
Attach the T-Pull with two #10-32 X
5/8" Phillips flat head screws, #10
washers, and #10-32 keps nuts.
(See diagram for pull location to
match your platform depth)
Attach Your Keyboard Platform
See the following diagrams to attach your WorkRite keyboard
platform to the Gemini Arm Platform Adaptor.
180S / 2180S / 2180SN Keyboard Platforms
3
4
Platform Adaptor
#10-32 X 5/8" Phillips Flat Head Screws
#10-32 Keps Nuts
#10-32 X 1-1/8" Phillips Flat Head Screws
#10 Washers
CONTENTS
WARNING
Failure to use appropriate
mounting hardware may result in
severe damage to the wall, the
eZ-arm, or the monitor.
!
#1500080
6X
2
Attach the Platform Adaptor
Attach the Platform Adaptor with
four #10-32 X 5/8" Phillips flat head
screws, #10 washers and
#10-32 keps nuts.
10/32 5/8"
FOR 11.5" DEEP PLATFORMS
FOR 13" DEEP PLATFORMS
STUDS
#10-32 X 5/8" PAN HEAD SCREWS
(PROVIDED WITH PLATFORM)
Classic Keyboard Platforms With Insert
INSERT
CONTINUED
Classic Reversible Keyboard Platforms
4
CONTINUED
4X STUDS
10X32X1-1/8" Flat Head (6X)
(PROVIDED IN ADAPTOR KIT)
10X32 WASHER (6X)
(PROVIDED IN ADAPTOR KIT)
CONTINUED
Ultra-Thin Keyboard Platforms
10X
6X
12X
#10-32 X 5/8"
#10-32 X 5/8"
PLATFORM
ADAPTOR
6X
#10-32 KEPS NUTS
(PROVIDED WITH PLATFORM)
4X
PLATFORM
ADAPTOR
#10-32 X 1-1/8" FLAT HEAD SCREWS
(PROVIDED WITH ADAPTOR KIT)
PLATFORM
ADAPTOR
6X
#10 WASHERS
(PROVIDED WITH ADAPTOR KIT)
6X
#10-32 KEPS NUTS
(PROVIDED WITH PLATFORM)
6X
#10-32 X 5/8" FLAT HEAD SCREWS
(PROVIDED WITH ADAPTOR KIT)
PLATFORM
ADAPTOR
6X
#10 WASHERS
(PROVIDED WITH ADAPTOR KIT)
6X
#10-32 KEPS NUTS
(PROVIDED WITH PLATFORM)
6X
USE MIDDLE HOLE