Xpres Sign Vinyl Application Guide - Manual

Phone:
Web:
E-mail:
Support: 01332 855 085
www.xpres.co.uk
[email protected]
www.xprestechnical.co.uk
®
Sign Vinyl Application Guide
ITEMS REQUIRED: XP6200 - Scissors M4 610mm Vinyl
XP2124 - Application Tape
A Starter Sign Making Kit can be purchased under the product code XP6100
XP6202 - Snappy safety cutter
SQU-W - Squeegee XP6170 - Scalpal XP6460 - Cutting Mat
STEP BY STEP
Step 3
Using Snappy safety cutter remove the finished item from the cutter.
Step 5
Place the application tape over the text ensuring the area is covered.
Oakridge Park, Trent Lane
Castle Donington, Derby
DE74 2PY
PLEASE NOTE: The sellers and manufacturers maximum obligation shall be to replace any product
that has been proven to be defective. Neither the seller nor the manufacturer of the items required
when following the guide shall be liable for any injury direct or consequential, arising out of the use of,
or inability to use this range.
Step 1
Place selected vinyl in to the cutter and carry out a test cut to make sure settings
and cut depth are correct.
Step 2
Place a weed line (keyline only) close around artwork to aid with weeding and
lining up on the vehicle substrate.
Step 4
Weed away the unwanted part of the vinyl and any centres
of logos and text.
Step 6
Using a squeegee, apply pressure and press the tape down to the lettering. You
will notice a colour change in the application tape as to where you have pressed
on.
Step 7
Place text/logo on to a cutting matt and cut along the weed
line and then remove from the surrounding waste.
Tips: Have a selection of widths of application tape to save on waste. Use the weed box as a method
of lining up text with the contour lines on a vehicle or sign.