Zippy M1G3-6930P - Manual (Page 6)

1.6 SPECIFICATIONS
INPUT CHARACTERISTICS:
M1G-6500P
l
VOLTAGE: 100V ~ 240VAC (WITH ± 10% TOLERANCE)
l
FREQUENCY: 47Hz ~ 63Hz
l
INPUT CURRENT: 9.0-4.5A MAX AT ANY LOW/HIGH INPUT VOLTAGE
l
INRUSH CURRENT: 65/125A @ 110/220VAC (25 )
l
POWER FACTOR CORRECTION: 95% @ 110V, FULL LOAD
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
OUTPUT
VOLTAGE
MIN. [A] MAX. [A] LOAD LINE
RIPPLE & NOISE
MAX. [P-P]
5V 1.5 24 ± 5% ± 50mV 70mV
12V1 1.0 16 ± 6% ± 50mV 120mV
12V2 1.0 26 ± 6% ± 50mV 120mV
-5V 0.05 0.7 +5%, -10% ± 50mV 120mV
-12V 0.05 0.7 +5%, -10% ± 50mV 120mV
3.3V 1.0 24 ± 5% ± 50mV 70mV
+5VSB 0.1 2.0 +5%, -6% ± 50mV 70mV
REMARKS:
1. THE OUTPUT POWER OF 5V & 3.3V MAX: 40A
2. +12V1 AND +12V2 TOTAL OUTPUT MAX: 36A
3. +5V, +3.3V AND +12V TOTAL OUTPUT MAX: 478W
SPECIFICATION:
l
TEMPERATURE RANGE: OPERATING: 0 --- 40
STORAGE: -20 --- 80
l
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE
l
DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 SECOND
INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND
l
EFFICIENCY: 67% TYPICAL AT 115VAC FULL LOAD
l
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
l
OVER POWER PROTECTION: 110% ~ 170%
OVER VOLTAGE PROTECTION: +5V à 5.7V ~ 6.5V, 3.3V à 3.9V ~ 4.7V
+12V à 13.3V ~ 14.3V
OVER CURRENT PROTECTION: 110% ~ 160%
l
SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V, +5VSB
l
EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A
l
SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950
l
REMOTE ON / OFF CONTROL
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE /
ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.
l
3.3V / 5V REMOTE SENSING
l
COOLING: ONE 40mm DC FAN
l
DIMENSION: 276 (D) x 106 (W) x 40 (H) mm