Zippy R2A-5350P - Manual (Page 5)

1.6 SPECIFICATION
INPUT CHARACTERISTICS: R2A-6300F/6320F
l
VOLTAGE: 115/230VAC AUTO VOLTAGE SELECTION (AVS)
l
FREQUENCY : 47 ~ 63 Hz
l
INPUT CURRENT: 7.0 / 3.2A FOR 115 / 230 VAC
l
INRUSH CURRENT: 40A / 80A MAX. FOR 115 / 230 VAC PER POWER MODULE
OUTPUT CHARACTERISTICS:
OUTPUT CURRENT REGULATION OUTPUT
MIN.[A] MAX.[A] PEAK(A) LOAD LINE
5V 3.0 32 ± 5% ± 1% 50mV
12V 2 16 20 ± 6% ± 1% 120mV
-5V 0.05 0.5 ± 10% ± 1% 150mV
-12V 0.05 0.5 ± 10% ± 1% 150mV
3.3V 1.0 20 ± 5% ± 1% 50mV
+5VSB 0.1 1.5 ± 5% ± 1% 60mV
OUTPUT
VOLTAGE
RIPPLE & NOISE
MAX. [P-P]
REMARKS: TOTAL CURRENT OF +5V AND + 3.3V NOT EXCEED 32 A
TOTAL +5V AND 3.3V AND 12V POWER NOT EXCEED 285/305 W
l
. TEMPERATURE RANGE : OPERATING 00C --- 400C, STORAGE –200C --- 800C
l
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & 90 VAC INPUT VOLTAGE
l
DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 MINUTE
INPUT TO FRAME GROUND 1500 VAC FOR 1 MINUTE
l
EFFICIENCY: 63% TYPICAL, AT FULL LOAD
l
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms
l
OVER LOAD PROTECTION: 110 ~ 160% MAX.
OVER VOLTAGE PROTECTION:
+5V
à 5.7V ~ 6.5V, 3.3V à 3.9 ~ 4.3V, 12V à 13.6 ~ 15.0V
. OVER CURRENT PROTECTION : 5V, 12V, 3.3V 130% +/- 20% AT FULL LOAD
-5V, -12V SHORT CIRCUIT
l
EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B
l
SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950
l
REMOTE ON / OFF CONTROL
l
FAULTY ALARM METHODS : LED, BUZZER, TTL SIGNAL
l
HOT-SWAPPABLE / HOT-PLUGGABLE REDUNDANCY FUNCTION
l
BALANCE LOAD SHARING DESIGN
l
REMOTE SENSING DESIGN
l
ISOLATION: BUILT-IN IN THE POWER MODULE
l
DIMENSION: 85(H) X 120(W) X 220 (D) mm
l
COOLING : TWO 40 mm DC FANS PER MODULE